Site Information


 Loading... Please wait...
  • Image 1
  • Image 2
  • Image 3
  • Image 4
  • Image 5
  • Image 6

Neff 2-Ton 3Ph Hydraulic Press Safety-Light-Curtains Adj-Press/Speed 7"-Travel X

Current Stock:

Product Description

Manufacturer: Neff

Model: Does Not Apply

Condition: For Parts or Not Working. This item comes in non-original packaging.  It has scuffs, scratches, surface rust, and grease residue from normal use. The photos show the exact item(s) the buyer will receive.

Notes: This press has an issue starting and continuing to run.  It is Very intermittent and may only run once or twice a day while trying to start it throughout the day.  When it does run it only lasts for a few minutes.  When it does run the Fault display (Cincinnati Electrosystems, model:  4161, 7-segment panel display) on the left orange electrical box shows all zeros and the Allen-Bradley programmable controller (model: SLC 500) in the right side orange electrical box has its power LED ON. 
The last time it ran I was able to maneuver the RAM up and down by using either the left or right side finger sensor in either the Run or Jog mode.  I was able to do it approximately 30 times in a two-minute time frame, then it would stop functioning and the display of all 0's and the Allen-Bradley power LED would both shut-off.  All the fuses and relays seem to be working properly.  During that run, if at any time the light curtain was crossed the RAM would stop indicating that the safety curtain was working correctly.  The pressure gauge is bad and will have to be replaced.  We were not able to test the pressure or speed adjustments. No further testing was done. No manuals, cords/cables, or additional items are included if not listed or shown.


  • (1) Neff 2-Ton 3Ph Hydraulic Press Safety-Light-Curtains Adj-Press/Speed 7"-Travel X


  • Manufacturer:  Neff
  • Model:  Unknown
  • SN:  P9978
  • Date:  11/94
  • Tonnage:  2 Ton / 2300 psi
  • RAM Travel:  7"
  • Safety Light Curtains
  • Pressure Adjustment
  • Pressure Guage
  • Speed Adjustment
  • Operating Pressure:  300 - 2300 psi
  • 2 Hp
  • 230/460VAC
  • 60 Hz
  • 3 Phase
  • Work Area/Base(without notch):  10-1/2"D x 11-1/2"W
  • Notch:  2"W x 4-1/4"D


  • No returns - No refunds - No exchanges
  • By purchasing this item, you are agreeing to not seek reimbursement should the item not function to the manufacturer's specifications.
  • Read the notes carefully to ensure you are buying something you can use
  • See complete terms

Other Details

For Parts or Not Working

Find Similar Products by Category