Kinetic Vibraplane 110x98cm Vibration Isolation/Height Leveling Table Pneumatic

Manufacturer: Kinetic Systems KS

Model: 390238-01-0082

Condition: For Parts or Not Working. This table is in Fair cosmetic condition with lots of minor scuffs/scratches from prior use.  The table top, especially the upper corners, has some rubbing through the finish.  All of the Ruby-I equipment except the pneumatics for the table have been removed, and several mounting and bolt holes are left behind.  The stage plate clamps have some pads and hold-down fingers missing.
The photos show the exact item(s) the buyer will receive.

Notes: This table is in Good working condition except for one important "but" ... but one of the top-height regulators is broken.  The fitting on bottom and the arm on top of the regulator are both snapped-off, so the table was replumbed to have only 2 zones of height regulation, effectively left/right or front/back.  When air is applied and all three switches are on, the table top lifts and the height is automatically regulated by the regulators beneath, and the frame is lifted off the wheels so the table can't roll around.  When the switches are off, the table rests on four rubber bump-stops on top of the frame, and the frame rolls easily on its casters.  No other testing was done.
No manuals, cords/cables, or additional items are included if not listed or shown.

Included:

• (1) KS Vibraplane Vibration Isolation Table

Specifications:

• Manufacturer: Kinetic Systems Incorporated (for DCG Systems)
• Model: 390238-01-0082
• Vibraplane vibration isolation table
• Isolates the top platform from vibrations via air suspension
• 2-zone automatic height regulation
• Rolls easily on wheels, then locks in place with air jacks to lift frame off the wheels
• Aluminum table top: about 110 cm x 98 cm x 1.5" thick
• Sides of top slope toward the middle, unsloped area about 101 x 91 cm
• Top height from floor (on casters, deflated isolators): 79 cm
• Rectangular opening in top 61 x 51 cm
• Round well in rectangular stage plate: 38 cm diameter
• Square opening in round stage plate: 8.5" square
• Swag pressure indicators turn green when air pressure is present
• Key switch for main air input
• Manual switches to enable frame lift and table leveling pneumatics
• Lots of threaded holes and three wells in top for mounting your equipment
• Threaded holes under table edges and around outside of frame
• Formerly part of a DCG Systems Ruby-I measurement system
• DCG model 20-101130-00
• Heavy! About 440 lbs.

AS-IS

• No returns - No refunds - No exchanges
• By purchasing this item, you are agreeing to not seek reimbursement should the item not function to the manufacturer's specifications.
• Read the notes carefully to ensure you are buying something you can use
• See complete terms

CDN Systems LLC, DBA Doug Deals, is not an authorized distributor or affiliated with the manufacturer of this product. Original manufacturer's warranty does not apply.